Montana State University Solar REU Program 2010
Margot Robinson


                          Home               Log               Flare List               Presentation               Additional Information

friday, july 23, 2010: Up through the first 20 flares, I now have centroid plots for all of the ones that I could get good images of.

FLARE 1: Not SHH - Max Movement of Left  FP: ~2 arcsec (stationary) - Max Movement of Right  FP: ~7 arcsec
Flare1Contours

Flare1

FLARE 4: SHH - Max Movement of Left  FP: ~15 arcsec - Max Movement of Right FP: ~10 arcsec
Flare4Footpoints
Flare4

FLARE 8:
Not SHH - Max Movement of Left  FP: ~7 arcsec - Max Movement of Right FP: ~10 arcsec
Flare8Contours
Flare8

FLARE 13:
SHH - Max Movement of Left  FP: ~10 arcsec - Max Movement of Right FP: ~12 arcsec
Flare13Contours
Flare13

FLARE 19:
SHH - Max Movement of Left  FP: ~18 arcsec - Max Movement of Right FP: ~30 arcsec
Flare19Contours
Flare19

FLARE 20:
Not SHH - Max Movement of Left  FP: ~2-3 arcsec (stationary) - Max Movement of Left  FP: ~4 arcsec (stationary)
Flare20Contours
Flare20

Flare
SHH
Left FP (arcsec)
Right FP (arcsec)
1
No
2
7
4
Yes
15
10
8
No
7
10
13
Yes
10
12
19
Yes
18
30
20
No
2-3
4

Note, my "measurements" of footpoint centroid movements are by-eye estimates, and I'll be redoing these to get exact numbers.

thursday, july 8, 2010:
Today I've been trying to make a good image of Flare 11, but I haven't been able to see any footpoints. I think that the problem is that the flare is right on the limb. Here is the best image I got in the 50-100 keV range.

Flare11s


wednesday, july 7, 2010:
Flare9ThermalContamCheck

This image is of my first time interval of flare 9 - the contours show a 50-100 keV plot and a 6-12 keV plot. This image confirms that the green at the top of the image is its own footpoint, not simply thermal contamination. I was worried that this was the case because this bright spot appeared only in the first interval, and then mysteriously disappeared.

Flare9FP1

This plot traces the movement of one of flare 9's footpoints. This is ultimately what I want to make for each of the footpoints of each of the flares. As the plot illustrates, the centroid of this footpoint migrates over a range of over 15 arc seconds over the entire interval that I imaged over.

tuesday, july 6, 2010:
I have now dropped flare 5,6,7, and 10 from my list. At the end of last week, I got an image of flare 8 and began working on flare 9.
Flare8LC
Flare8_50-100keV

From this image of flare 8, it is clear that the flare has footpoints, but it would be very difficult to determine just how much they move. So, I tried imaging adding detectors 1 and 2 in, and it produced this image. Although there seem to be enough counts, some of the intervals are still not the cleanest looking.

Flare9_d1,2Added

Now, I've made a first image of flare 9, in 35-100 keV (shown below). What I need to do now is break up those final two intervals, which I had made longer because I was afraid that ther didn't have enough counts.
Flare9_1

Flare9_2

Huh. This may have just made the image more confusing. I divided the final two intervals into 16 second intervals, but it looks like they are still big footpoints. I am fairly certain that I don't have enough counts to image over an even smaller interval. So, either the footpoint is moving really fast at the end there, or it just attains a larger area.

tuesday, june 25, 2010:
Since last week, I have concentrated on making lightcurves for the next couple of flares, to avoid having to go back and forth a lot and speed up the process of getting through my list. I struggled a little bit with discerning footpoints in flare 5, and eventually Angela and I decided to scrap that flare from the list of ones we are studying - it must simply be too small to see the footpoints. Here is an image of flare 6, which makes me worried that we may have a similar problem (I've imaged in the highest energy available, 50-100keV).


Flare8_50-100keV
This is an image from the beginning of flare 8 that I've been looking at. I imaged over a much longer interval but kept on getting garbage out of the later times. I might now want to go back and try a 35-100 keV image so that I can have enough counts to break the image up into smaller time intervals and maybe see clearer footpoint movement.


friday, june 24, 2010:
Flare4LightCurve
The lightcurve for flare #4.


wednesday, june 23, 2010:

Flare4_35-100keV
This is the next image of flare 4 - the footpoints are really clean and easy to discern here, as I imaged in the 35-100 keV range. I'm just going to make one more image now of this with a 6-12 keV interval contoured on top so that we can have a really clear idea of where the thermal part of the flare is located relative to the nonthermal.

Flare4_35-100CW6-12
Ok, here I've contoured a 6-12 keV image over a 35-100 keV one. Both are from the same interval -- 01:12:00 to 01:14:00 -- near the beginning of the flare (right after the last attenuator interruption). This should be giving us a pretty clear depiction of the structure of the flare - in terms of general footpoint and top location.
Flare4_ModifiedThis is just a redone version of the image at the top of today. There were too many contours to include all of the later intervals, but I wanted to redo the earlier, shorter ones and change them from 15 seconds to 12 seconds, as we get more reliable images if we use intervals that are divisible by 4 seconds.

tuesday, june 22, 2010:
Flare4Part1
Latest images on flare #4. I couldn't contour everything on top of one another because there were just too many time intervals. So, the three images to the right are in chronological order. Interestingly, it seems like the footpoint movement gradually quiets down as the flare progresses. Angela and I discussed this morning how this stabilization in the footpoints' locations may corrolate to when the SHH flares begin their final hardening. I can't confirm this - but it is similar to the guess I made about the previous flare, which also exhibits SHH behavior.

Flare4Part2
Flare4Part3

monday, june 21, 2010:
Flare3
To the right is an image of Flare #3 (April 17, 2002) with contours. All of the time intervals shown are in the 25-50 keV range. This flare is interesting because one footpoint, evident in the later time intervals , is relatively stationary, while the other (shown in blue, green, and cyan) migrates around within a range of about 10 arcsec. The yellow interval seems to be the only time when both footpoints are visible, and this made me interested in imaging a 6-12 keV together with it. Using these two together, I may be able to get a clearer picture of where the thermal part of the flare is located with respect to the nonthermal footpoints.

Flare2_SchematicThis image is not ideal. I tried adjusting the detectors (cutting out the first 2 of 9) but still the green contours (25-50 keV) below the 6-12 keV contours are not the only ones present in that time range. Still, we can get some idea of the structure of the flare from this comparison of the thermal and nonthermal components.
Flare4FootpointsTo the right is my first image of the fourth flare (April 21, 2010). For the later times, it seems like the footpoints migrate only within a roughly 10 arcsec interval. However, the earliest 2 time intervals are in a very different place. This makes me wonder about the location of the lower energy components. So, I'm going to go back and make a plot of a 6-12 keV interval with some of these higher energy ones contoured on top.


thursday, june 17, 2010:
2_6-12keVwith35-100keVContours
For the same flare (#2) that I was working on yesterday, I wanted to try to isolate the non-thermal component so that I could actaully see where the footpoints are. So, I looked at images with the same time interval in the 35-100 keV range. These are shown on the left contoured on top of the original 6-12 keV plot (red contours). From this plot, the location of the footpoints is much clearer, so we must have eliminated any thermal contamination from previous plots. Although we really need a centroid plot to determine where exactly the footpoints are, it seems like they are the more isolated globs above (cyan) and below (green). Now, I am goign to work on the centroid plotting program so that I can see the evolution of the footpoints more clearly.


wednesday, june 16, 2010:

Flare 2 - 6-12keVWith25-50kevContoursToday, I realized that the contour plot that I made yesterday was in fact a 12-25keV plot, so I re-plotted the correct version on the left. It made sense that the previous plot looked very similar to the 6-12 keV plot, as we can see they are very similar from the light curve for flare 2.


tuesday, june 15, 2010:

Flare2Contours
I produced this image of the second flare that I am studying. The colors, again, encode the progression in time for the 25-50 keV emission. Their order is:

1)Blue
2) Green
3) Violet
4) Cyan
5) Lime
6) Maroon

These are contoured on top of the 6-12 keV plot for this flare. It seems like the lima-bean shaped contours are expanding with each successive time interval. This would mean that the footpoints are in fact moving away from one another.


monday, june 14, 2010:

Flare1Contours
Today I created this image of the first solar flare in my list - on February 25, 2002. The colored contours indicate increasing time intervals. They progess in the following order:
1) Blue - this is simply the contour of the plot that this shown here
2) Green
3) Cyan
4) Violet
5) Pink

Since the last two time intervals (pink and violet) show the flare spreading out to the left, we catagorized this flare as one in which the footpoints are moving. However, this flare does not exhibit SHH behavior, so this conclusion does not bring us closer to investigating the link between SHH behavior and footpoint migration.


thursday, june 10, 2010:

cl_25-50_d1-9_02:56:00-02:28:00
I began my imaging of the flare data. The image on the right is of the February 25, 2002 flare, looking specifically at the 25-50 keV range. I have overlayed the contour of the 6-12 keV image in blue. The ultimate goal of my project is a.) To identify footpoints if possible in the 37 flares we are working with and b.) To see if these footpoints migrate over the course of the flare. The footpoints should be visible in the HXR range - so overlaying lower energy plots may help me to identify them. In the image to the left, for example, the footpoints could be any of the brighter points below the blue contours. However, we need more information before we can specify their location for sure.
















wednesday, june 9, 2010:
Today was very productive. I spent the morning reading the paper on Spectral Hardening which I understood a surprising amount of. I feel more confident now about what the question I am working on is and why we are interested in it. I then met with Angela, went through the reading, and figured out how to download the raw RHESSI data onto /disk/data/rhessi so that I can start imaging. I downloaded data for three flares this afternoon, which we will start to image tomorrow. I also went to a tutorial on Spectroscopy with Dana, Cameron, and Angela.



tuesday, june 8, 2010: Today I spent the morning reading the Cambridge Encyclopedia of the Sun in preparation for our lecture this afternoon, and I also took a look at a few of the other papers that Angela gave me. At one, I met with Angela to go over the work that I had done - going over GOES and RHESSI flare data from the paper "Spectral Hardening in Solar Flares" that my project is based off of. We went through the schematic of RHESSI from one of the articles that I had read, which clarified how it detects and locates the origin of incoming photons. Next, Dana gave us a lecture on "The Sun as a Star," which was basically an introduction to the structure of the Sun - how it supports itself against gravity, generates energy at its center through nuclear reactions, and then transports this energy up to the surface. Between now and my meeting tomorrow morning with Angela, I plan to read through the "Spectral Hardening" paper mentioned above and begin to download the data I need for my imaging project. As soon as the site comes back up, I will also go back to the flares that I marked originally for various problems and see if I can sort that out after having spoken to Angela today.